Last week we installed a Two Brothers Racing V.A.L.E.™ M-7 Carbon Slip-on on our Yamaha WR250X project bike. I've ridden the bike a few times with it and couldn't be...
Read more →
Click the YouTUbe video above for a brief overview of the aftermarket front turn signal / flasher options available for the 2008+ Yamaha WR250R and WR250X. Where To Buy: •...
Read more →
Click video above for a brief overview. We recently installed Zeta Armor Hand Guards on our WR250R and WR250X Project Bikes. For the WR250R... On our WR250R, we installed Zeta...
Read more →
I've had a Delta Barrel 4 exhaust on the WR250X project bike for the last two summers, and it was time to re-pack it so I thought it would be...
Read more →
(click photos above) I've received a few email requests to post close-up photos of the IMS 3.1 gallon gas tank to show how it fits on the bike with the...
Read more →
Click video above for a short overview of the DRC Edge Tail Light kit we installed on our WR250R and WR250X project bikes. Also mentioned in the video is the...
Read more →
The WR250X comes from the factory with basically a set of dirt bike footpegs. They provide a descent amount of grip, but have a pretty narrow platform for your boots...
Read more →
Today I got my new Zeta Racing ED Skid Plate mounted. I don't do any serious off-roading with this bike, but occasionally venture onto some gravel roads and you just...
Read more →
Even though I really like the all black plastic on my 2009 WR250X, I decided to change up the look of the bike this spring. So, I ordered a set...
Read more →
After about 3000 miles the stock rear tire on my WR250X was completely shot. I was going to just replace it with another Bridgestone BT-090 Battlax, but decided I wanted...
Read more →
I decided it was finally time to get a GPS for the motorcycle. I have a Garmin Nuvi 765T in my car, but wanted something a bit more worthy of...
Read more →
Here's a short video clip to show how the Delta Barrel 4 exhaust system sounds on my 2009 Yamaha WR250X. Here are the mods I've done to the engine... •...
Read more →
Since I still have the stock handlebars on my WR250X, I decided to go with Acerbis Rally Pro X-Strong Handguards . I had read these guards fit the stock bars...
Read more →